1.Foundation requirement Our company's dry extruder machine has heavy body weight, low vibration, works steady. But also need reinforced with foot bolts. Pay attention to bearing capacity when design. No other special request, but the smooth ground. 2.Installation environment Extruding process works under high temperature, take care of ventilation when install. It would be better […]

1.equipment installation Consider the flow diagram(intake, discharge, cool), confirm floor number and relative position. And also need to take care of the space position, so as to easy operate and satisfy bearing request, ensure safety and reasonable production. 2.foundation Equipment foundation made according to request of extruder drawing, pouring scree concrete to meet bearing request,

In recent years, the using of double screw extruder increases in the production of extruded pellets, the extruding principle if the same as single screw extruder. the difference is that the heat is not from screw extrusion materials resulting "strain hot", also set up a dedicated external heating and temperature control device, and a major

Compared to single screw fish feed extruder, double screw fish feed extruder machine has below features: 1) Material flow is stable, uneasy happen cutoff or billow, productive process is reliable. 2) Most heat of double screw extruder mainly come from mechanical transformation during operation, small amount of heat comes from the heating jacket. The single

Process of wet fish food extruder machine could be divided into three sections according to the function and position: feeding, compressing and extruding. ① Feeding section: transport and compress the tempered material, making material full fill screw chute. bolt in this section is single-start thread, which takes up10%~25% of bolt full length. ② Compressing section:

This part will mainly about the working process of the wet extruder by taking the wet type extruder machine as an example. The wet extruder is mainly used for producing floating fish pellet feed, pet feed and sinking aquatic feed or for developing resources. 1.The raw materials enter the DDC through the feeder and get

The output and equipment configuration of different small wood pellet plants are different, and the prices are also different. Please leave your contact information online, and our sales staff will contact you to provide you with detailed information and quotation of the equipment. Also welcome to visit: 1.Wood Pellet Production Plant 2.Wood Chips Pellet Production

The feed for the production of commercial eggs should have the basic characteristics of low cost of compound feed, good quality, low egg production cost, and high feed conversion efficiency. For laying hens before 50 weeks of age, the feed conversion efficiency of laying eggs is relatively lower; after 50 weeks of age, in addition

1. Implement layered reclaiming: When taking silage, start from one end of the cellar, and take it down from the surface layer by layer according to a certain thickness, so that the green fodder always maintains a flat surface. Do not dig a hole from one place. 2. Seal the pit mouth in time: After

1. Harvest: silage corn and cereal crops. Harvest time is from Suckling stage to wax-ripening stage.Grasses were heading stage;Legume herbage is the flowering stage of present bud. 2.Transportation: The harvested silage shall be delivered to the silo in time.　 3. Chopping and cellaring: the silage shredder is used to cut the silage into 2-5 cm

1) Feeding precautions: For the extruder's higher requirement about material finesse, it is easy for the material to get blocked. It is better to equip a feeding barrel with self-cleaning scraper on the feeding auger, making sure materials can be continuously got into the expanding chamber. 2) Machine open precautions: Start feeding in small volume

To master the conventional standards, a small amount of concentrated feed can be put into the spring; the daily feeding amount in early summer accounts for 1% to 2% of the total weight of the fish; the feeding amount in the summer season accounts for 3% to 4% of the total weight of the fish;